I have a Brother HL-L8360 dual tray, color laser printer and I have a problem.
I have only had it about 14 months. At first there were just a few random, inconsistent spots where the text would be a little lighter than the rest on a page, usually on the left side.
Now almost the entire right side is very light. I can still read the text but it’s definitely not acceptable to use for closing documents.
The drum is still at 64% and all of the toner cartridges are nearly full.
Anyone ever have this problem? If so, how did you fix it?
Isolate the paper: Take the paper currently in the tray and flip it top-to-bottom.
Test fresh paper: Place entirely fresh, dry paper in the tray and compare the print quality.
Determine the side: If the print quality does not change with fresh paper, the issue is on the machine side.
Slide the corona wire cleaner: Pull out the drum/toner cartridge assembly and look for a small blue or red plastic slider on top of the cartridge unit.
Clean the wire: Slide that tab all the way across to the other side and back two times, returning it completely to its original starting position. (Note: This cleans the thin copper corona wire that provides electrical charges to the drum).
Agitate the toner: Remove the toner cartridge, gently shake it from left to right a few times to redistribute the powder, and reinsert it.
Replace the drum: Test a print; if the lines or quality defects persist after all these steps, replace the drum unit.
I should’ve invested in brother printer stock before the six figure notary guru started selling this business over the Internet. Now to your question.
On most Brother laser printers (color and mono), the drum unit has a small green plastic tab on the top/side. You gently slide it left and right several times to clean the corona wire, which helps prevent streaks or the “Drum Error – Slide the Green Tab” message. Always return it to the home position afterward.